Camshaft Tester

A CAMSHAFT: MEASUREMENT AND ANALYSIS

camshaft measurement and analysis

A camshaft plays like a timing device that manages the opening and closing of the ingestion and depletion valves and also fixing the valve overlap that performs at top dead center on the exhaust stroke. The shaft is built with numerous journals which ride on comportments inside the engine. It has egg-shaped lobes that stimulate the valve train, either by the moving pushrods and lifters or by pushing straight on valve stems. The camshaft is constrained to crankshaft turning by chain’s timing, timing belt or timing gears, and the failures in camshaft drive can permit the valves to interact the piston crowns, that cause widespread internal destruction.

The Additional Camshaft Functions:

The camshafts in mature engines may also have gears automated into them that execute the distributor and the oil pump. For modern engines, the camshaft may have a situation sensor attached to the end that transfers data to the powertrain control unit to help the module right time your fuel injection pulsations and ignition. Some engines can have several camshafts, like with some overhead cam machines, mainly ones built in a “V” structure. Engines that have a desmodromic valvetrain use minimum 2 cams, as there is 1 push-open cam and 1 pull-close cam, in place of the classic push-open cam along with valve springs to pull the valve shut as the cam revolves past the lobe and back on to the circle base.

The Camshaft Measurement:

Entire lobe measurement, graphic presentation and lift analysis, acceleration, velocity, bump (3rd derivative) radius of curving, angle’s pressure

Lobe data modified and brought to zero base circle run-out

Camshaft can have Angular position listings for all lobe tip angles

It can be equaled measured data and design lift data profiles in numeric and graphic modes

Screen graphic presents for all motion curvatures

You will be accessible to printed reports of tabular data and screen graphics

Compare base circle radius, run-out, and lobe tip angles to design data representing tolerance restrictions

It may also have inch or metric data output and input

EZCAM programs and operates run under Windows

Computer managed camshaft revolution on mechanical versions

It includes HeidenhainTM sensors and data assortment hardware

Only one size measuring probe required, irrespective of engine follower size

User preset set up included for other languages also

The Camshaft Analysis:

The investigation volumes of analysis include the capacity to apprehend static and dynamic structural analysis, steady-state and transient issues, more frequency and buckling Eigen value issues, static or time-varying magnetic analysis and different sorts of field and coupled implementations. The program has many extraordinary components which permit non-freedoms or optional affects tube combined into the fixtures like plasticity, hyperelasticity, large strain, creep; swelling, large deflection contact stress stiffening temperature reliability, material anisotropy, and radiation. As analysis was produced, other unique sizes, for instance, surface organizing, sub modelling, piezoelectric, irregular vibration, coupled field analysis and design improvement was added to the package.

These abilities support further to make analysis a multipurpose analysis device for changed designing order. The analysis package has been in business use since late 90’s and it is utilized widely in the aviation, development, automotive, benefit, electronics, vitality, fabricating atomic or nuclear, oil and steel ventures. Additionally, many counselling firms and several colleges and universities apply analysis for examination, explore and instructive operate.